Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may locate that your garage door opener has been giving you troubles, so you require to repair it. You can fix it by replacing a motherboard, a photo-eye sensing unit, the main drive equipment, or the set-limit switches. You can likewise examine if the safety sensors are working appropriately.

Changing a motherboard

Changing a motherboard for your garage door opener requires a few actions as well as devices. Initially, you need to turn off the circuit breaker as well as separate any kind of cables. Next, open up the circuit card cover. This will help you to identify the problem and also determine if you require a brand-new board. Next, eliminate the old board and also its cord connectors.

You can then continue to replace the circuit board. The replacement process is very easy and also takes around 10 minutes. A brand-new circuit card will certainly set you back concerning $80. To protect your new circuit card from power rises, you can purchase a surge protector.

Replacing a photo-eye sensing unit

Replacing a photo-eye sensor can be a fairly easy job. First, get rid of the sensor from the door as well as make sure it is positioned appropriately. If the sensor is angled by any means, it might not be receiving the appropriate signal, which could be causing the strobe lights. If you see that the photo-eyes run out placement, you may require to have actually a technician come as well as deal with the problem.

The photo-eye sensor contains two pieces that place on the outside of the door tracks and also towards the flooring. The photo eyes will have a tiny LED light and ought to be solid in color. If the light is blinking, its likely the photo-eye is faulty as well as will require to be replaced.

Replacing a major drive equipment

To replace a garage door opener main drive equipment, start by getting rid of the cap from the chain pulley. Next off, remove both screws holding the drive gear to the sprocket setting up. Currently, you can loosen the 3 stress pins. Squeeze them from both sides and then remove them. After that, detach the 3 wires from the garage door opener motor. These cables need to be white, red, as well as blue.

As soon as you have actually eliminated the old equipment, install a brand-new one. Make certain to oil it well. Put the brand-new gear right into the shaft, making sure to align the placing holes. Ensure the gear as well as gear setting up are located correctly to ensure smooth procedure. Next off, utilize a hammer and also a nail to drive a pin into the new equipment.

Adjusting the set-limit buttons

The initial point you ought to do if your garage door is not functioning properly is to examine the set-limit switches. You may need to adjust them to ensure that the door closes earlier or stops before it gets to the floor. You can check this by taking a look at your garage doors manual or online.

To adjust the set-limit buttons, youll need a screwdriver or outlet. Readjust the handle clockwise or counterclockwise till the door moves up and stops, or lowers its distance. To look for appropriate traveling range, measure the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top